ESPEasy

Easy MultiSensor device based on ESP8266/ESP32

WIZnet

Published August 05, 2024

Original author: letscontrolitOriginal source (new tab)

Components

Hardware components

WIZnet - W5500

x 1

Espressif - ESP32S

x 1

WIZnet parts

W5500 Datasheet

Project description

ESPEasy is an open-source firmware designed to run on low-power microcontrollers such as the ESP8266 or ESP32, which are commonly used in Internet of Things (IoT) devices. It allows users to easily connect and manage various sensors and actuators without needing extensive programming knowledge. ESPEasy is primarily used in applications like smart homes, environmental monitoring, and industrial automation. Key Features and Characteristics Sensor and Actuator Support: ESPEasy supports a wide range of sensors, including temperature, humidity, light, and pressure sensors, as well as actuators…

Keep reading with a free account

Guests can read 15 projects per visit. Log in or create a free account to read the full description, open the documents and join the comments.

Similar projects you might like

A peer-reviewed 2026 paper wires an ESP32, three PZEM-004T sensors, and a W5500 Ethernet module into the BMKG Sleman station LAN to log 3-phase kWh in MySQL.

How Does a W5500 Wired ESP32 Monitor 3-Phase Power at a BMKG Geophysics Station?

Benjamin

Views 90
Comments 0

Five: Modbus TCP, S7, PROFINET DCP, OPC UA and EtherNet/IP. This ESP32-S3 firmware runs the W5500 in promiscuous mode to read Layer 2 frames.

Which Industrial Protocols Can a W5500 and ESP32-S3 Detect on an OT Network?

Benjamin

Views 161
Comments 0

In this open KiCad gateway an ADIN1110 holds the 10BASE-T1L pair and a W5500 carries it onto standard Ethernet, both on one ESP32-S3 over separate SPI buses.

How Does a 10BASE-T1L Field Port Reach Standard Ethernet Through a W5500?

Benjamin

Views 98
Comments 0

ULSTU put a W5500 on the ESP32 board of its Ackermann teaching robot, so a Jetson AGX Xavier sends JSON-RPC drive commands and reads IMU data over wired UDP.

Why Does a W5500 Ethernet Link Carry ROS 2 Drive Commands in the ULSTU Buggy?

Benjamin

Views 132
Comments 0

hexinttp's ESP-IDF firmware maps Modbus RTU and TCP registers to named points, publishes them over MQTT, and serves 11 MCP tools, with W5500 as default route.

How Does an ESP32-S3 Modbus Gateway Serve Field Points as MCP Tools over W5500 Ethernet?

Benjamin

Views 219
Comments 0

YamBMS is an ESPHome project that merges parallel BMS units into one battery for the inverter. Its two ESP32-S3 Ethernet board files both configure a W5500.

How Does YamBMS Merge Multiple ESS BMS Units for One Inverter Over W5500 Ethernet?

Benjamin

Views 145
Comments 0

BREMA firmware makes busware's TUL KNX stick answer MCP over HTTP, so an agent can commission KNX devices. A PoE W5500 extension is the wired path.

How Does BREMA Make a KNX Stick Its Own MCP Server, and Where Does PoE W5500 Fit?

Benjamin

Views 252
Comments 0