Project 062a Arduino W5100 Ethernet Shield, LED and SG90 Micro Servo Motor ? Webserver
Project 062a Arduino W5100 Ethernet Shield, LED and SG90 Micro Servo Motor ? Webserver
0
Components
Hardware componentsArduino Uno R3
x 1
Arduino W5100 Ethernet Shield
x 1
Jumper cables M-M
x 1
Breadboard
x 1
Resistor (220 Ohm)
x 1
LED
x 1
SG90 Micro Servo Motor
x 1
Capacitor 100 uF
x 1
Arduino
x 1
Project description
The Arduino Ethernet Shield V1 allows an Arduino board to connect to the internet. It is based on the?Wiznet W5100?ethernet chip (datasheet). The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. The ethernet shield connects to an Arduino board using long wire-wrap headers that extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top. The most recent revision of the board exposes the 1.0 pinout on rev 3 of the Arduino UNO board. The Ethernet Shield V1 has a standard…
Keep reading with a free account
Guests can read 15 projects per visit. Log in or create a free account to read the full description, open the documents and join the comments.