ESPHome-W5500-Ethernet-on-ESP32-boards

mason

Published February 05, 2024

182 UCC

21 WCC

27 VAR

Original author: Bart OlaertsOriginal source (new tab)

Components

Hardware components

WIZnet - W5500

x 1

Espressif - ESP32

x 1

WIZnet parts

W5500 Datasheet

Project description

Introduction to Integrating ESP32C3 with ESPHome and W5500 Ethernet Module This project explores the integration of the ESPHome framework with the W5500 Ethernet module on various ESP32 boards, focusing on the ESP32C3 Super Mini. The objective is to utilize the SPI interface for Ethernet connectivity while employing I²C for additional sensors or extensions. The ESP32C3 Super Mini board, despite its small size, offers sufficient connectivity for the W5500 module and extra peripherals. A key aspect of this integration involves configuring the CLK wire for the W5500's SPI bus, with an initial…

Keep reading with a free account

Guests can read 15 projects per visit. Log in or create a free account to read the full description, open the documents and join the comments.

Similar projects you might like

Ooznest board support in grblHAL/ESP32 routes Telnet, WebSocket, FTP and WebUI over a W5500 SPI Ethernet link on the ESP32-S3, with Wi-Fi compiled alongside.

Why Did CNC Vendor Ooznest Choose W5500 Ethernet for Its grblHAL ESP32-S3 Board?

Benjamin

Views 117
Comments 0

Surat factory WiFi is unreliable, so the EaseEmbro MES gives its ESP32-S3 fingerprint terminal a W5500 wired Ethernet option. The platform runs 33 factories.

Why Did EaseEmbro Put a W5500 Wired Option in Its ESP32-S3 Attendance Terminal?

Benjamin

Views 94
Comments 0

A peer-reviewed 2026 paper wires an ESP32, three PZEM-004T sensors, and a W5500 Ethernet module into the BMKG Sleman station LAN to log 3-phase kWh in MySQL.

How Does a W5500 Wired ESP32 Monitor 3-Phase Power at a BMKG Geophysics Station?

Benjamin

Views 89
Comments 0

Five: Modbus TCP, S7, PROFINET DCP, OPC UA and EtherNet/IP. This ESP32-S3 firmware runs the W5500 in promiscuous mode to read Layer 2 frames.

Which Industrial Protocols Can a W5500 and ESP32-S3 Detect on an OT Network?

Benjamin

Views 160
Comments 0

In this open KiCad gateway an ADIN1110 holds the 10BASE-T1L pair and a W5500 carries it onto standard Ethernet, both on one ESP32-S3 over separate SPI buses.

How Does a 10BASE-T1L Field Port Reach Standard Ethernet Through a W5500?

Benjamin

Views 97
Comments 0

ULSTU put a W5500 on the ESP32 board of its Ackermann teaching robot, so a Jetson AGX Xavier sends JSON-RPC drive commands and reads IMU data over wired UDP.

Why Does a W5500 Ethernet Link Carry ROS 2 Drive Commands in the ULSTU Buggy?

Benjamin

Views 132
Comments 0

hexinttp's ESP-IDF firmware maps Modbus RTU and TCP registers to named points, publishes them over MQTT, and serves 11 MCP tools, with W5500 as default route.

How Does an ESP32-S3 Modbus Gateway Serve Field Points as MCP Tools over W5500 Ethernet?

Benjamin

Views 219
Comments 0