W6100 Parallax P2 E1.31 decoded and displayed on LEDs
W6100 Parallax P2 E1.31 decoded and displayed on LEDs
0
Components
Hardware componentsProperller2
x 1
Propeller 2 Multicore Microcontroller
P2 Edge Module Breadboard
x 1
W6100 Parallax P2 E1.31 decoded and displayed on LEDs
0
Properller2
x 1
Propeller 2 Multicore Microcontroller
P2 Edge Module Breadboard
x 1
ESP32-S3 7-inch display that polls two Samwoo lithium packs over RS-485 and serves them over a W6100 wired port via SNMPv2c, a web monitor, and IP Finder.
Samwoo Lithium Battery Display with W6100 SNMPv2c, Web Monitor, and RS-485 Pack Polling
josephsrViews 61
Comments 0
mikroSDK 2.20.2 adds shared Ethernet APIs for W5500 and W6100, using MACRAW drivers and host-side ARP, ping, DHCP and HTTP examples.
How Does mikroSDK Unify W5500 and W6100 Behind One SPI Ethernet API?
BenjaminViews 30
Comments 0
TinyDesk draws a windowed desktop from an ESP32 into a serial terminal, with Wi-Fi, optional W6100 Ethernet, RS-485, and MQTT/Modbus apps.
TinyDesk: A Windowed Text-Mode Desktop Served by an ESP32, with Optional W6100 Ethernet
josephsrViews 130
Comments 0
Summary Power Manifold is a six-port managed USB-C Power Delivery supply built around an RP2350 , independent charger blades, and a WIZnet W6100
How to Build a Managed USB-C Power Controller with WIZnet W6100 on RP2350?
viktorViews 108
Comments 0
Native ethernet: config for WIZnet W6100 SPI and W6300 PIO QSPI on RP2040/RP2350, merged by Home Assistant developer bdraco and shipped in ESPHome 2026.4.0.
What Does ESPHome Support for W6100 and W6300 Ethernet Add on RP2040 and RP2350?
BenjaminViews 246
Comments 0
This project presents a STM32F4 + WIZnet W6100 framework for IPv6 communication using UDP.
How to Implement IPv6 UDP Communication with W6100 on STM32F4?
markViews 158
Comments 0
W5500/W6100 support in ESP-IDF opens the door for deeper WIZnet–Espressif collaboration, including Hardwired TCP/IP and W6300.
Espressif Adds Official W6100 Ethernet Driver Support to ESP-IDF
jakeleeViews 316
Comments 0
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?