ESP32 Audio Docks and Louder ESP

Louder ESP Audio Dock is a combination of external I2S DAC capable to drive full size speakers and PSRAM chip. And W5500 is used as an option.

WIZnet

Published February 27, 2024

Original author: sonocottaOriginal source (new tab)

Components

Hardware components

WIZnet - W5500

x 1

Espressif - ESP32

x 1

WIZnet parts

W5500 Datasheet

Project description

ESP32 Audio Docks is a range of extension boards (i.e. docks) that allow you to develop Audio solutions based on ESP32 chips. These were created to make Audio development entry as easy and inexpensive as possible. Development Platform for Audio Applications: The ESP32 Audio Docks and Louder ESP provide a development platform for audio applications based on the ESP32 chip. Open Source: The platform is open source, allowing developers to customize and extend it for their specific needs. Extensive documentation and tutorials are available to help developers get started with the platform. Ideal…

Keep reading with a free account

Guests can read 15 projects per visit. Log in or create a free account to read the full description, open the documents and join the comments.

Similar projects you might like

Surat factory WiFi is unreliable, so the EaseEmbro MES gives its ESP32-S3 fingerprint terminal a W5500 wired Ethernet option. The platform runs 33 factories.

Why Did EaseEmbro Put a W5500 Wired Option in Its ESP32-S3 Attendance Terminal?

Benjamin

Views 94
Comments 0

A peer-reviewed 2026 paper wires an ESP32, three PZEM-004T sensors, and a W5500 Ethernet module into the BMKG Sleman station LAN to log 3-phase kWh in MySQL.

How Does a W5500 Wired ESP32 Monitor 3-Phase Power at a BMKG Geophysics Station?

Benjamin

Views 89
Comments 0

Five: Modbus TCP, S7, PROFINET DCP, OPC UA and EtherNet/IP. This ESP32-S3 firmware runs the W5500 in promiscuous mode to read Layer 2 frames.

Which Industrial Protocols Can a W5500 and ESP32-S3 Detect on an OT Network?

Benjamin

Views 160
Comments 0

In this open KiCad gateway an ADIN1110 holds the 10BASE-T1L pair and a W5500 carries it onto standard Ethernet, both on one ESP32-S3 over separate SPI buses.

How Does a 10BASE-T1L Field Port Reach Standard Ethernet Through a W5500?

Benjamin

Views 97
Comments 0

ULSTU put a W5500 on the ESP32 board of its Ackermann teaching robot, so a Jetson AGX Xavier sends JSON-RPC drive commands and reads IMU data over wired UDP.

Why Does a W5500 Ethernet Link Carry ROS 2 Drive Commands in the ULSTU Buggy?

Benjamin

Views 132
Comments 0

hexinttp's ESP-IDF firmware maps Modbus RTU and TCP registers to named points, publishes them over MQTT, and serves 11 MCP tools, with W5500 as default route.

How Does an ESP32-S3 Modbus Gateway Serve Field Points as MCP Tools over W5500 Ethernet?

Benjamin

Views 219
Comments 0

YamBMS is an ESPHome project that merges parallel BMS units into one battery for the inverter. Its two ESP32-S3 Ethernet board files both configure a W5500.

How Does YamBMS Merge Multiple ESS BMS Units for One Inverter Over W5500 Ethernet?

Benjamin

Views 145
Comments 0