F411-Tepelco-W5500
Introduction to Ethernet and Wi-Fi to Modbus Conversion Using STM32F411 and W5500
mason
Views 3433

Comments 0
User Created Content: projects that makers and community members built with WIZnet chips and modules.
25 projects
F411-Tepelco-W5500
Introduction to Ethernet and Wi-Fi to Modbus Conversion Using STM32F411 and W5500
masonViews 3433
Comments 0
Rewired-S uses the WiNet-S2 W5500 interface to expose Sungrow inverter data through local web, MQTT and Modbus TCP, with a new Ethernet recovery feature.
How Does Rewired-S Use W5500 Ethernet for Local Solar Monitoring in Home Assistant?
BenjaminViews 98
Comments 0
Open-source gateway reads an Amphenol Wilcoxon 883M vibration sensor over RS-485 and serves a PLC, MQTT and a web dashboard through the IRIV's W5500 Ethernet.
How Does a W5500 on the Cytron IRIV Turn a Wilcoxon 883M Vibration Sensor into a PLC-Ready Node?
ElenaLeeViews 187
Comments 0
STM32F407 gateway using WIZnet W5500 for Modbus-to-MQTT monitoring, offline data buffering, OTA rollback, and automatic 4G failover.
stm32f407-iot-gateway
lawrenceViews 176
Comments 0
Industrial Modbus gateway: STM32F103 + FreeRTOS firmware (Modbus RTU<->TCP, W5500, OTA with dual-partition bootloader) and a Linux host
modbus-gateway
lawrenceViews 214
Comments 0
Kontrx is a bare-metal STM32F407 + FreeRTOS industrial edge gateway for water-quality monitoring. It doesn't just "have Ethernet"
KONTRX
lawrenceViews 182
Comments 0
Weidos doesn't use the W5500 as a plain Ethernet PHY/interface. Its official Ethernet.h-based library talks directly to the W5500's hardware TCP socket (TOE).
Weidos-ESP32-package
lawrenceViews 240
Comments 0
Full hardware TCP/IP stack, eight sockets, a dedicated 32 KB buffer, 80 MHz SPI. UCF Group 21 wrote the comparison down, then measured the chip on its bench.
Why the W5500 Beat the ENC28J60 and AX11001 in a UCF Animatronic Trade Study
BenjaminViews 208
Comments 0
Five: Modbus TCP, S7, PROFINET DCP, OPC UA and EtherNet/IP. This ESP32-S3 firmware runs the W5500 in promiscuous mode to read Layer 2 frames.
Which Industrial Protocols Can a W5500 and ESP32-S3 Detect on an OT Network?
BenjaminViews 285
Comments 0
Going's Senbrino ladder IDE has an MCP server inside, so an AI edits the ladder itself. Senbrino then builds Arduino C++ for a W5500 Modbus TCP board.
How Does Senbrino Turn AI-Edited Ladder Logic Into an Arduino Sketch on a W5500 PLC Board?
BenjaminViews 242
Comments 0
expand I/O channels over Ethernet
Modbus TCP between 2 Industruinos
masonViews 181
Comments 0
controling a set of disinfection lights based on sensor readings
IND.I/O switching application with Modbus TCP
masonViews 196
Comments 0
A Bengbu University patent application links RS-485 sensors to a GD32F303CET6 gateway that packages data as MQTT and sends it through W5500 Ethernet.
How Does a W5500 Gateway Convert Modbus Sensor Data to MQTT?
BenjaminViews 277
Comments 0
PLC_PRS10
PLC_PRS10
lawrenceViews 562
Comments 0
MonSet is an industrial-grade IoT monitoring device built around the STM32F407VET6 microcontroller. It reads sensor data over Modbus RTU (RS-485)
MonSet-Dev
lawrenceViews 446
Comments 0
ModbusTCP_RU is an Arduino library for building Modbus TCP Master and Slave devices on boards equipped with W5100 or W5500 Ethernet controllers.
ModbusTCP_RU
lawrenceViews 597
Comments 0
This project demonstrates a robust, production-ready Modbus TCP Sensor Node utilizing the STM32F411CEU6 (BlackPill) as the primary MCU and the W5500 Hardwired T
STM32F411CEU6_W5500_BME280_Modbus
lawrenceViews 897
Comments 0
This project is a simple example of implementing a Modbus TCP client using an ESP32 and the W5500 Ethernet controller.
esp32-modbus-w5500
lawrenceViews 1035
Comments 0
STM32 BluePill-based analog monitoring system using the WIZnet W5500 Ethernet module. Measures temperature, voltage, and current with external high-resolution A
STM32_Modbus_AnalogRead
lawrenceViews 899
Comments 0
ESP32 with W5500 logs Growatt RS485 Modbus data to ThingSpeak every 120s for stable wired solar monitoring.
How to Log Growatt Solar Inverter Data with W5500 on ESP32
jakeleeViews 562
Comments 0
MODBUS_TCP_IP_with_Arduino_STM32_W5500
MODBUS_TCP_IP_with_Arduino_STM32_W5500
masonViews 1193
Comments 0
3-year field-proven IIoT Gateway using W5500 & RT-Thread. Zero downtime Modbus-to-MQTT solution on low-cost MCUs.
Zero Downtime for 3 Years: A Battle-Tested Industrial IoT Gateway with W5500 & RT-Thread
Grace_KooViews 611
Comments 0
Industrial gateway solution based on STM32 and W5500, supporting multiple protocols (Modbus TCP/RTU/ASCII, BACnet/IP, MQTT) for building automation and IIoT.
Industrial Multi-Protocol Gateway (MTGateway)
BenjaminViews 1552
Comments 0
Professional IoT training webinar demonstrating TCP client-server implementation using WIZnet W5500 and STM32, plus MODBUS TCP server development
DevHeads IoT Community - Hands-on W5500 Ethernet Implementation with STM32 MCU Workshop
BenjaminViews 3259
Comments 0
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?