W6300-EVB-PICO2にArduinoVNCを移植する話

matthew

Published December 16, 2025

166 UCC

9 WCC

47 VAR

1 Followers

1 Following

Original author: Kazumasa Ueda · JapanOriginal source (new tab)

Project description

Title Porting ArduinoVNC to W6300-EVB-PICO2: replacing Wi-Fi with W6300 wired Ethernet (DHCP), avoiding SPI conflicts, and pushing toward a tiny thin-client Introduction This project is a practical porting story from kazueda’s Zenn article (published 2025/12/14): taking an ArduinoVNC sketch originally built for Raspberry Pi Pico W (Wi-Fi) and moving it onto WIZnet’s W6300-based W6300-EVB-PICO2. The author doesn’t just claim success—they documents the exact engineering steps that make embedded ports reliable: swapping the network stack, stabilizing reset timing, pinning the display bus to…

Keep reading with a free account

Guests can read 15 projects per visit. Log in or create a free account to read the full description, open the documents and join the comments.

Similar projects you might like

Web Radio Control's GPL-3.0 azimuth rotator firmware added W6300 support on 2026-08-04. PlatformIO default_envs names W6300-EVB-Pico2 before two Wi-Fi Picos.

Why Does This Open-Source Antenna Rotator Firmware Build for W6300-EVB-Pico2 First?

Benjamin

Views 102
Comments 0

SSH Stamp turns W6300-EVB-Pico2 into a secure UART bridge and improves MACRAW reliability for Embassy.

SSH Stamp: Secure Remote UART Access with W6300-EVB-Pico2

Grace_Koo

Views 122
Comments 0

W5500/W6100 support in ESP-IDF opens the door for deeper WIZnet–Espressif collaboration, including Hardwired TCP/IP and W6300.

Espressif Adds Official W6100 Ethernet Driver Support to ESP-IDF

jakelee

Views 253
Comments 0

WebSocket on a WIZnet ESP SoM. TCP runs on the Ethernet chip, not the MCU. Same firmware on W5500 or W6300 - one menuconfig switch, no porting.

WebSocket on the WIZnet ESP SoM: the MCU never runs TCP

TheoIm

Views 332
Comments 0

Modbus TCP slave plus a live web dashboard on a WIZnet ESP SoM. Change the IP from the browser. Same firmware on W5500 or W6300, one menuconfig switch.

Modbus TCP on the WIZnet ESP SoM, re-addressable from a browser

TheoIm

Views 326
Comments 0

Waveshare's RP2350-POE-ETH pairs the dual-core RP2350A with WIZnet's W6300 hardwired TCP/IP controller and an onboard RJ45, with optional 802.3af PoE.

Waveshare RP2350-POE-ETH: RP2350A + WIZnet W6300 Ethernet Board with Optional PoE

ElenaLee

Views 169
Comments 0

The plc-comm-slmp-cpp-minimal project implements Mitsubishi Electric MELSEC SLMP Binary 3E and 4E communication for embedded C++ systems

How to Connect MELSEC PLCs with Binary SLMP 3E/4E on W6300-EVB-Pico2?

viktor

Views 188
Comments 0