RP2040 + W5500 LED controller in Rust: receives sACN (E1.31) over Ethernet and drives 8 WS2812B outputs; open PCB and MIT license.
hydra-nano
November 10, 2026
Views 50

Comments 0
RP2040 + W5500 LED controller in Rust: receives sACN (E1.31) over Ethernet and drives 8 WS2812B outputs; open PCB and MIT license.
hydra-nano
November 10, 2026Views 50
Comments 0
ESP32-S3 locker controller: W6100 Ethernet serves an HTTP page that shows PN532 RFID card UIDs, switches 24 relays and takes OTA updates.
driver_locker-restapi-code
November 10, 2026Views 38
Comments 0
W6100-EVB-Pico2 joins ROS 2 over wired Ethernet: a 101-line micro-ROS UDP transport on W6100 sockets, publishing IMU, GNSS and servo topics.
MicroRos-Pi-W6100-EVB-Pico2
November 10, 2026Views 31
Comments 0
Pico SDK robot library for W6300-EVB-Pico2: a non-blocking W6300 UDP socket API alongside RoboMaster CAN motor, PID and WS2812 drivers.
hkdt_pico
November 10, 2026Views 30
Comments 0
A W55MH32L-EVB paints 772-byte RGB frames streamed over UDP onto an 8x32 WS2812B matrix, counting dropped frames on an OLED instead of hiding them.
Real-Time UDP Pixel Display & Stage Visualizer
October 08, 2026Views 84
Comments 0
UnreaLin01's mlx90640-rp2350-stream reads an MLX90640 thermal array on a WIZnet W6300-EVB-Pico2 and ships raw sensor data to a PC over USB or UDP.
mlx90640-rp2350-stream
September 23, 2026Views 528
Comments 0
https://github.com/christophebelmont/Flow.io-Waveshare
Flow.io-Waveshare
September 02, 2026Views 205
Comments 0
An ESP32-S3 reads a LiFePO4 BMS over BLE and publishes it as MQTT over a W5500 PoE link, where Node-RED turns it into a Victron virtual battery.
esp32poeLarsBatMon
September 02, 2026Views 201
Comments 0
protective-stop
protective-stop
August 28, 2026Views 288
Comments 0
Higenis HG-ESP32-S3-RLY4-PRO + W5500: an ESP32-S3 industrial controller that drives real relays over UDP via SPI Ethernet.
ESP32-S3 High-Current 4-Channel Relay Controller + W5500 UDP Relay Control Demo and Source Code
August 28, 2026Views 243
Comments 0
STM32H5-W6300 (Hygenis Board) Firmware OTA and Web Server Bootloader Project
STM32H5-W6300 - Firmware OTA & WebServer
August 28, 2026Views 241
Comments 0
QuackPLC uses W5500 hardware TCP to serve OPC UA while keeping its 1 kHz PLC scan timing stable without lwIP or an RTOS socket layer.
muc-opcua
August 13, 2026Views 243
Comments 0
ProtoCore runs multiple network services on ESP32-S3 via W5500, reaching ~8.2 Mbit/s over SPI with verified large-file transfers.
ProtoCore
July 31, 2026Views 305
Comments 0
Build a precision agriculture guidance system using ESP32, dual ZED-F9P GNSS receivers, and WIZnet W5500 Ethernet for accurate RTK heading and reliable AgOpenGP
Two Antennas, One Accurate Heading: Building a Dual GNSS Guidance System with W5500 and AgOpenGPS
July 31, 2026Views 271
Comments 0
Build an interactive art installation using ESP32-S3 and WIZnet W5500 Ethernet, replacing unreliable Wi-Fi with stable wired OSC communication for 1,740-pixel s
NaoDec: A Dodecahedron That Had to Go Wired — W5500 Inside a 1,740-Pixel Art Installation
July 31, 2026Views 247
Comments 0
picoArtnet2DMX is an open-source gateway that converts Art-Net lighting data from Ethernet into DMX512 signals using a Raspberry Pi Pico and the WIZnet W5500.
picoArtnet2DMX
July 23, 2026Views 262
Comments 0
Coloruino sends motion commands over Ethernet to a WIZnet W5500-based Arduino running USB Host Shield and HID firmware.
temprepo
July 23, 2026Views 211
Comments 0
This project demonstrates a Matter-over-Ethernet device running on a stock Raspberry Pi Pico, a board without built-in Wi-Fi or Ethernet.
rs-matter-embassy
July 14, 2026Views 245
Comments 0
A telescope-automation maker uses WizFi360 AT commands, UDP discovery, and HTTP/JSON responses to expose a custom astronomical device to N.I.N.A. over a local.
How Does WizFi360 Connect a DIY ASCOM Alpaca Cover Calibrator to N.I.N.A.?
July 14, 2026Views 251
Comments 0
HWANHEE NET-CHECKER: ESP32+W5500 handheld LAN tester for quick on-site IP, gateway, DNS, and loop checks.
ESP32 + W5500 + TFT 기반 HWANHEE NET-CHECKER 제작기
July 07, 2026Views 315
Comments 0
This project converts a USB keypad into a wired ONYX playback controller. An ESP32-S3 receives USB HID key events, maps them to ONYX OSC playback executors.
OSC-KEYPAD-ONYX
July 01, 2026Views 324
Comments 0
This project bridges Art-Net DMX to NovaStar TCP control using an Arduino-compatible MCU and a W5500 Ethernet interface, enabling reliable wired LED screen.
novastar_Uno_Interface
July 01, 2026Views 239
Comments 0
This project provides an Arduino framework that connects physical cockpit controls to the X-Plane flight simulator over UDP using an Arduino Ethernet Shield.
ardxp
July 01, 2026Views 276
Comments 0
An ESP32-S3 solar heating controller using the W5500 for reliable Ethernet monitoring and remote pump control in residential thermal systems.
ESP32_S3_DevKitC_1_N8R8_Solar_Controller_4.9
June 25, 2026Views 226
Comments 0
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?