Wiznet makers

ArtGateOne_2

ESP32-S3-ETH Devkit에서 ESP-IDF를 활용하여 W5500 기반 Ethernet을 설정하고, 안정적인 유선 네트워크 환경을 구축하는 과정을 다룹니다.

ESP32-shield-module-W5500-RS485

xugongke Solar energy

A configurable MCU platform simulates incremental and SSI encoder outputs, injects faults, and converts them into industrial differential signals for PLC test.

A Zephyr RTOS driver PR for WIZnet W6300 on RP2350, using bit-bang SPI + MACRAW mode. Currently under review.

An ESP32-S3 CCTV/IoT firmware combining W5500 Ethernet, motion detection, SD recording, MQTT, and a web UI for wired LAN camera nodes.

An ESP32-C6 gateway uses the W5500 to bridge a CAN-based smart home network to an MQTT cloud.

ESP32-S3 uses W5500 Ethernet over SPI to run as a standalone ROS 2 node, enabling stable RTPS communication without Wi-Fi or external agents.

NFC/RFID card reader on RP2350 + W6300 that sends card UIDs over TCP with a built-in web configuration UI

A DIY PoE access panel built on WIZnet W5500 + ESP32-S3, featuring 3D face, vein, and fingerprint auth via ESPHome and Home Assistant.

Open-source KiCad PCB design for a 4-universe ArtNet LED controller with RP2040, W5500, USB-C charging, and JLCPCB assembly support

This project is a hardware design for an autonomous wheeled vehicle main control board built around the STM32 Nucleo F446RE.

This project is a compact sub-control board for an autonomous wheeled vehicle that uses a Seeed XIAO SAMD21, a WIZnet W5500 Ethernet module

Devices that need to stay connected without worrying about WiFi interference, the W5500 is my go to choice for adding Ethernet to an ESP32.

The ESP32-S3-ETH is a powerful microcontroller module manufactured by WAVESHARE (Part ID: ESP32-S3-POE-ETH).

WLED usermod that receives DDP pixel data over W5500 Ethernet while using WiFi for relay control

SLMP C++ Minimal Console App

TextFinder is a lightweight Arduino stream-parsing library designed to extract strings, integers, and floating-point values from incoming text data.

Atom_POE_ENVIII is a wired environmental monitoring project that delivers ENV III sensor data through WIZnet W5500 Ethernet and PoE for stable, installation-fri

KNX W5500

This project introduces the WIZnet W5500 Ethernet controller and explains how it is used in embedded systems.

Building a commercial game show venue — need the most reliable microcontroller setup for buzzers + LEDs +Ethernet

This project explains how to connect an STM32 MCU to the WIZnet W5500 over SPI and use it as the Ethernet communication engine for embedded TCP/UDP applications