MT011 is an RC2014 compaitible ethernet controller based on the w5500

Description

The?mt011?is an?RC2014?compaitible ethernet controller based on the?w5500?wiznet chip with a?Featherwing?breakout board.

This board was developed by Mark T with input from Jay Cotton.

Building

make NIC=w5500 HBA=mt011

Using

To run this board with CP/NET there are a few things that are needed. A ROM/RAM board with?RomWBW?v3.0.1 or newer. The MT011 board.

The MT011 does not reset the W5500 during system RESET, so it retains settings during system RESET-reboot. The W5500 may be reset by software, when required.

##On your CP/M console: ###CP/M 2.2

b:pip a:=c:ccp.spr  (assumes your cpnet code is installed on the c drive)
c:ifconfig -s (https://github.com/jayacotton/inettools-z80)  (this command gets a DHCP address for the wiznet board)
c:wizcfg 0 0 <host ip address> 31100 45
c:cpnetldr  (this loads the cpnet bios code )
c:network k:=c:[0]  (k on my machine, YMMV)

###CP/M 3.0

c:ifconfig
c:wizcfg 0 0 <host ip address> 31100 45
c:network k:=c:[0]

##Caveat's

The above assumes you have a server running on a host machine somewhere. See cpnet-z80/doc/CpnetSocketServer.pdf for information on running the server.