WizFi 630 - Can't connect to other Wifi using Serial-Command

Question

Because of your Suggest in your QnA-Answer to use this Forum, i transfer my Issue to this Thread.: Hello! All commands used so far (except the “GF”-Command) work correctly. And as I tried to mention: The “GF”-Command correctly adds a specific Profile, but doesn’t activate it. …It doesn’t log in to the Wifi which is specified by the Profle. Kind regards, Christian Grunbacher [quote] Dear customer. Thanks for your interest in WizFi630. Please, confirm all command doesn’t work or specific command you said doesn’t work. P.S. : We open WIZwiki forum. index.php We take care of it a lot. So, use it a lot, please. Thanks. WIZnet. [quote] Hello! I need to configure my WizFi630 through the Serial-Command-Interface and stumbled over following Problem: When Using the Wizfi630 in Client(Station)-Mode, i can’t connect to another Wifi. → The Command “GI” can’t be used, because the target-AP broadcasts a WPA-PSK-Network and no WEP → The Command “GU” (although it is suggested in the manual) can’t be used in client(station)-Mode. → So my only chance to connect is by creating a Profile using the “GF” command. → Creating a Profile with the correct settings works, but the WiZi630 doesn’t connect to it… → …unless i go to the Web-Interface log in and click on the “Profile” section. (nothing else) …But i in my Application i have to connect to a Wifi by using serial-commands and no Web-Interface-Inputs. I would be very thankful if you could help me with this problem! [/quote][/quote]

greeni86 · Answer

In the meantime, i discovered following (ugly) workaround: Sending the Command restarts the WizFi and after that, it connects to the WiFi which i have configured previously with the Command. But… this leads me to the next Problem: I Cannot delete Profiles using the Command. → I always get the Error <2> (“Command Parameter is mismatch”). (And yes, i sticked to the given Example in the Manual which says to use the Set-Profile Command like …but of course with the correct parameters after “

kaizen · Answer

Dear customer Thanks for your interest in WizFi630. If you want to delete profile using command, you have to use command parameter like . If enter correctly, WizFi630 will return message. Thanks WIZnet

greeni86 · Answer

Dear Support, thank you for your answer! This solved my Problem, regarding the deletion of Profiles. (Maybe you should correct this Command in the Serial-Command-Guide located at: wiznet.co.kr/Admin_Root/UpLo … %201.2.pdf )