W5500 NOT WORKING
Ethernet Chips
- W5500
No replies yet. Be the first to reply.
Join the discussion.
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: W5500 NOT WORKING
by Sunny_ WIZnet ·
Hello, this is Hyerin Kim from WIZnet.
After reviewing your schematic, we recommend the following modifications:
1.TCT resistor
The resistor in the RJ45 TCT power supply path appears to be 49.9Ω. Our primary recommendation is to change this resistor to 10Ω. A higher resistance can increase the voltage drop and reduce the voltage supplied to the TCT, potentially affecting the transmit signal and preventing link establishment.
2.MDI damping resistors
We recommend changing the MDI damping resistors from 33Ω to 3.3Ω. Using 33Ω may increase signal attenuation, potentially causing communication failures with longer Ethernet cables.
3.Reset circuit
We recommend adding a capacitor of at least 1uF between nRST and GND to support reliable initialization at power-up. Although this capacitor is not shown in the W5500 reference schematic, insufficient power-on reset (POR) timing may cause the device to initialize incorrectly. Adding this capacitor can help delay reset release until the power supply stabilizes.
Thank you.
RE: W5500 NOT WORKING
by nbabu0001 ·
Hi Hyerin,
Thank you for your response. Could you able to give me your email address, i can send you the whole file with footprints and schematic. I'm not sure if the RJ45 connector is compatible with the circuit. I will make the changes you mentioned above. I really appreciate your help.
RE: W5500 NOT WORKING
by Sunny_ WIZnet ·
Please send the files to sunny@wiznet.io.
I will review the schematic and let you know whether the RJ45 connector is compatible.
Thank you.
RE: W5500 NOT WORKING
by nbabu0001 ·
I just sent you an email—please let me know if it didn't come through. Thanks.