Serial connection between two wizfi360
Wireless
No replies yet. Be the first to reply.
Join the discussion.
Wireless
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: Serial connection between two wizfi360
by wizdaniel ·
Hi,
WizFi360 supports only AP, STA and AP-STA modes.
So, If you want to create WiFi link with 2 of WizFi360 modules,
one of the module have to run the AP or AP-STA mode.
then, the other module can connect to the AP module to make WiFi link.
The modules can be set by AT Commands.
please refer to an AT Instruction set in link below.
https://wizwiki.net/wiki/doku.php/products:wizfi360:wizfi360ds:start
RE: Serial connection between two wizfi360
by Snake ·
I know, i have two wizfi360 connected together and with TCP protocol is no problem, but it is too slow for my application. I need send few bytes every 100 ms, so the best way should be some bridge or somethink like that. I just want send to uart &h05 and on the other side the same text → &h05. Is it possible ?
thanks for link or AT commands
RE: Serial connection between two wizfi360
by wizdaniel ·
Sorry Snake,
We do not recommend fast cycle of transmission.
RE: Serial connection between two wizfi360
by Snake ·
Oh, OK thanks.
What about UDP connection with transparent transmission ? Yesterday I found forum with AT commands for esp32 but it works… not sure with 100ms but its acceptable.
See: ESP-WROOM-32 AT commands firmware - Page 4 - ESP32 Forum
RE: RE: Serial connection between two wizfi360
by wizdaniel ·
It is need to test.
Usually, Transparent mode is slower than AT command mode.
I’m not sure that the WizFi360 can transmit data stably every 100ms.
but, UDP + AT command mode is the best performance of WizFi360.