forcing client disconnection from WIZ107sr serial commands
Serial-to-Ethernet & ConfigTool
No replies yet. Be the first to reply.
Join the discussion.
Serial-to-Ethernet & ConfigTool
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: forcing client disconnection from WIZ107sr serial commands
by irina WIZnet ·
Hi, @tecnico_2emme.
You can terminate an existing TCP connection by entering the serial command mode!
Please send the 3-bytes command to our module to enter the serial command mode and, immediately exit the command mode with the ‘EX\r\n’ command.
)
(‘\r\n’ means CR and LF
Please take caution of the following when using Trigger code.
It can only be recognized as switch code if there is a time gap of at least 500ms of no data communication time before and after the 3-byte command mode switch.
The time interval for each byte of the 3-byte command mode switch code has to be at most 500ms.
Do not end the command mode switch code10) with CR or LF.
The default interval of the time gap before and after the command mode switch code is 500ms. The operation is based on the timer value of the serial data packaging option.