Precisioin about AT+WCHECK please

Question

Dear, in the description, you write : [quote] Format: AT+WCHECK=,, Meaning: Check Wi-Fi status using Ping and Re-association with AP It must be set as service mode in order to use Re-association function. This function only exist later vision of F/W 1.0.3.5. [/quote] i don’t find any 1.0.3.5 FW version !.. just 1.0.3.3 then 1.0.4.2 … is it available on 1.0.3.3 ? when the 1.0.4.2 will become ‘stable’ version ? thanks, regards

wizdaniel · Answer

Hi phil31 As you know, You can just use 1.0.4.2 version for using AT+WCHECK 1.0.3.5 version is a private version because it is too unstable to release. Thanks.

phil31 · Answer

thanks daniel then when do you plan to switch 1.0.4.2 to “stable” ? regards

ssekim · Answer

Hello phil31 You can consider 1.0.4.2 is stable. Thanks.

phil31 · Answer

is it an official update ? thanks

wizdaniel · Answer

Hi, A 1.0.4.2 is not official firmware, it is a beta version. but you can only use AT+WCHECK at 1.0.4.2. Thanks

phil31 · Answer

Hello, i’m using now 1.0.5.2 i set AT+WCHECK=10,5,3 (if i right understand, do automatically PING to the AP, each 10 seconds and reboot if failed answer) i right receive the [OK], but i don’t see (wireshark) any PING request from my WIZFI device ! did i miss something please ?

phil31 · Answer

Wiznet team, as you stop the development of your W250, do you stop too the forum support !? thanks