Skip to content

Measure the indoor environment with xiao RP2040 and sensor and send it to zabbix

Measure the indoor environment with xiao RP2040 and sensor and send it to zabbix

Components

Hardware components

x 1

Seeed


x 1

DF Robot SEN0339


x 1

SSCI-022361


x 1

Software Apps and online services

Project description

Original : https://zenn.dev/kaede_asatsuki/articles/193ffb276c371c

Introduction

I started using the XIAO RP2040 for the keyboard, but since it's a big deal, I thought I'd try using it for something else, and I tried to measure CO2 and so on.

Purpose

Measure the following environmental data around the desk and in each room to find a guideline for ventilation.
  • temperature
  • Humidity
  • CO2 concentration
The measurement data will be displayed on the OLED, and the values ??will be accumulated using the existing Zabbix (v5.0 series).

Hard and soft to use

hardware

  • Seeed XIAO RP2040
  • CCS811 (CO2 sensor)?DF Robot SEN0339
  • BME280 (Temperature / Humidity Sensor)?SSCI-022361
  • Wiznet W5500 (communication module)?WIZ850io
  • SSD1306 (128 * 32 that I had)

software

  • CircuitPython *?XIAO's WIKI?has UF2 for XIAOR P2040, so use it.

About the circuit

  • Sensors and OLEDs are connected via I2C. * Since the XIAO RP2040 has only one set of I2C PINs, all of them are connected in parallel from the same SDA / SCL PIN on the circuit.
  • WizNet W5500 connects with SPI and connects RST with any GPIO PIN.
  • All power supplies are connected at 3.3v.
  • Since the I2C address of the BME280 sensor used this time is determined by the SDO PIN connection, there is a manual description to connect it to VCC or GND.?This time I will connect it to GND.?(The address will be 0x76)
I referred to the following sites for communication around W5500 and transmission to Zabbix. Try to grow a wired LAN port on Raspberry Pi Pico --Akii Diary Send to Zabbix while using 1-Wire temperature sensor on Raspberry Pi Pico --Akii Diary

Documents

  • Try to grow a wired LAN port on

  • Raspberry Pi Pico --Akii Diary Send to Zabbix while using 1-Wire temperature sensor on

Comments

Similar projects you might like

Comments