Skip to content

Home Automation with Self-learning 433 Power Switches

Home Automation with Self-learning 433 Power Switches

Project description

Home Automation with Self-learning 433 Power Switches

What’s Connected

The project exits off: ? Arduino UNO ? W5100 LAN module ? 433-module ? RTC-module (DS3231) ? Self-learning power switches Added functionality: ? Daylight Saving Time for CET ? Sunset/Sunrise calculation The RTC-module (DS3231) is added for two reasons. ? Unaware if the time can be retrieved from Cheyenne ? Store in the alarm if we are on DST-time or not Some lines are set to comment, you can use this section to reset your RTC-module and/or to set a new time. In this section you also “give the “DTS_check the initial correct value; DST in CET is calculated a bit odd).

Triggers & Alerts

The Present time, sunrise and sunset are used to calculate if it is night time or not: if (time_now >= time_sunset or time_now <= time_sunrise) { and saved as a digital sensor. This sensor is used in a trigger to switch light on/off at sunset/sunrise.

Scheduling

Sunset and sunrise is calculted daily at 2 AM. Some lights will switch off at pumkin time (others on sunrise done with a trigger).

Dashboard Screenshots

The dashboard: Home Automation with Self-learning 433 Power Switches, Dashboard Screenshots Trigger: Home Automation with Self-learning 433 Power Switches, Dashboard Screenshots   Original links: Relational links:    

Comments

Comments