Arduino Ethernet and SD card shield (WIZnet W5100)

Standard Arduino Ethernet shields use the WIZnet W5100 chip, which provides hardware support for TCP/IP. The W5100 is?supported out of the box by?Pixl.js Most other offical Espruino boards have firmware with support for the?WIZnet W5500?and will not work with the W5100 without a special firmware build.

Wiring

The Ethernet shield shown above exposes the W5100 through pins on the Arduino 2x3 pin?ICSP?header (which isn't present on?Pixl.js) rather than the standard Arduino footprint. To connect it up, you will need to add 3 wires to the shield (mirroring the connections there would be on an Arduino UNO board), connecting:

• ICSP MOSI to?D11
• ICSP MISO to?D12
• ICSP SCK to?D13

 ---------------------------------
|              D13  D12  D11      |
|              SCK MISO  MOSI     |
|                                  
| ETH                               |
| JACK                              |
|                                   |
|                        MISO ---   |
|                        SCK  MOSI  |
|                        ---- GND   |
|                                   |
|                         SD CARD   |
|                                   |
|                                   |
| RESET                            /
 ----------------------------------

The easiest method is to remove the?ICSP?header completely and add wires on the underside of the board.   Original Link:?https://www.espruino.com/arduino-w5100