Skip to content

SPI Problem on W5500 With STM32G474RE

Discussion about trouble intergrating W5500 SPI with an STM32G474RE MCU on a Nucleo board but facing troubles due to communication speed.

jakelee

Published December 17, 2025

Original author: KirtanOriginal source (new tab)

SPI Problem on W5500 With STM32G474RE

Components

Hardware components

x 1

WIZnet parts

Project description

🔎 Context & Setup A community user reported trouble interfacing W5500 SPI with an STM32G474RE MCU on a Nucleo board. The intention was to communicate over SPI from the STM32 to the W5500 to run Ethernet services (e.g., TCP/IP). However, the interface failed above a certain communication speed. 🧪 Symptom of the Problem The user observed that data transmission over SPI to the W5500 worked only up to ~18 MHz. Above ~18 MHz, the data packets did not reach the W5500 — as if nothing was transmitted. Attempts to push SPI baud rates higher caused communication failure without clear error feedback…

Keep reading with a free account

Guests can read 15 projects per visit. Log in or create a free account to read the full description, open the documents and join the comments.

Similar projects you might like