W5500 Configuration Tool
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: W5500 Configuration Tool
by Eugeny ·
Configuration tool is called DHCP. The respective application note and maybe even code available on the WIZnet website.
RE: W5500 Configuration Tool
by irina WIZnet ·
Hi~ Century
We supports the configuration tool for W5500S2E-S1(Serial to Ethernet module).
Link : W5500S2E in wikipage
This site included User manual document and Configuration Tool.
I think you refer the above link.
thanks,
BR
irina
RE: RE: W5500 Configuration Tool
by Century ·
Hi, irina
We are using only W5500 chip and communicating by SPI protocol through our texas chip.
I downloaded the .exe file and using, the W5500 chip is not identified by the config tool.
RE: W5500 Configuration Tool
by Philipp K ·
I’d say that that’s because if you only use the chip directly connected to your MCU, either your application has to configure the W5500 via SPI (e. g. using the C driver) or you need to use DHCP as Eugeny suggested, then it will receive its IP settings from a DHCP server (e. g. your router) like any other LAN device
EDIT: Spelling