W7100_A Serial to Ethernet
Serial-to-Ethernet & ConfigTool
No replies yet. Be the first to reply.
Join the discussion.
Serial-to-Ethernet & ConfigTool
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: W7100_A Serial to Ethernet
by scott WIZnet ·
Hi rajesh_9949
Do you using W7100A_S2E?
If you are using the W7100A_S2E, make sure the LINK LED and ACT LED are on.
Thank you.
RE: W7100_A Serial to Ethernet
by rajesh 9949 ·
Dear sir,
we are having the Chipset (WIZnet iMCU W7100A NC2FY-002 1538) with sticker pasted on the chip is W7100-S2E. The EVK chipset number is (WIZnet iMCU W7100A NF3CS-001 1625).
After power ON our custom board the voltage on the LINK LED & ACT LED pin is 3.2V but 0V is showing on the EVK Board.
please reply