WIZ107 not showing on Configuration Tool

Question

Hi, I’ve tried to activate newly purchased WIZ107SR with Configuration Tool ver 1.4.4.1. Search window: 10.0.1.60 50001 After search was done, at the bottom of Configuration Tool window: Find: 0 devices None devices selected After a while, a popup window shows: “A connection failed because the connected party did not properly respond after a period of time, or established connection failed because connected host has failed to respond 10.0.1.60:50001” Hardware: Pull up resistors 10K on pins 4,6,8 LED on pin 8 Environment: Windows7 (x64), firewall is OFF, no virtual box. Indicators: When ethernet cable is connected, LEDs on RJ45: One is steady ON, other is blinking irregularly. LED on pin 8 is OFF. When ethernet cable disconnected, both RJ45 LEDs OFF, LED on pin 8 blinks at 1sec rate. Supply voltage is 3.0V. What can I do? It seems a very nice device. Best regards Goran

goranpop · Answer

Hi again, I managed to detect both my WIZ107 and WIZ108 by using UDP. It is explained in WIZ107SR_UM_V171E.pdf while in WIZ107_108SR_AN_S2E-Programming-Guide_V100E.pdf a TCP seemed the only option. May this help the others Goran

irina · Answer

Hi, Goran. Thank you for sharing your problem solving experiences. Thanks.