Configuration via telnet; firmware version
Wireless
No replies yet. Be the first to reply.
Join the discussion.
Wireless
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: Configuration via telnet; firmware version
by ssekim ·
Even though you can configure something via telnet, it is not for configuration.
Current official F/W is <1.1.25> and <1.1.28> or something is not official F/W.
As I know, there is no big difference between <1.1.25> and <1.1.28>.
RE: Configuration via telnet; firmware version
by ChrHa ·
What do you mean 1.1.28 is not an official firmware? It is installed on some of the modules we’ve received from an official WIZnet distributor.
On status_content.asp it is listed as “DS620P-4M-usb-sta-1T1R_v1.1.28-2013/04/09, 10:53:05”. The modules we’ve received with 1.1.25 display “DS620P-11n-4M-usb-sta-PCIe_v1.1.25-2012/07/26, 03:24:45” on this page.
I’ll be happy to provide the mac addresses of the affected modules if it helps WIZnet clarify this situation.
RE: Configuration via telnet; firmware version
by ssekim ·
It means that WIzfi630 are mass-produced in WIZnet’s factory with <1.1.25>. (not <1.1.28>)
So, if you want WizFi630 <1.1.28> in much quantity, I think that you had better discuss with the distributor.
In other words, when you order WizFi630, you should specify the f/w version(you need).