The IoT based pollution system will help us to fetch the data from any location where the device is installed.
4
Arduino - Arduino Ethernet Shield 2
x 1
Guests can read 15 projects per visit. Log in or create a free account to read the full description, open the documents and join the comments.
PP-Ethernet-UART-HAT is a 45 x 30 mm PLATYPUS module that converts 3.3 V UART to Ethernet on a WIZnet W55RP20 and ships with W55RP20-S2E firmware preloaded.
Which PLATYPUS W55RP20 Module Converts 3.3 V UART to Ethernet Without Custom Firmware?
Benjamin
Views 68
Comments 0
hexinttp's ESP-IDF firmware maps Modbus RTU and TCP registers to named points, publishes them over MQTT, and serves 11 MCP tools, with W5500 as default route.
How Does an ESP32-S3 Modbus Gateway Serve Field Points as MCP Tools over W5500 Ethernet?
Benjamin
Views 219
Comments 0
Alexey Titov's Eva node fits a wall box by splitting in two: sensors and a W5500 on the front PCB, RJ45 and a PoE module on the back.
How Does the Eva Wall-Box PoE Sensor Split W5500 Ethernet Across Two Boards?
Benjamin
Views 138
Comments 0
YamBMS is an ESPHome project that merges parallel BMS units into one battery for the inverter. Its two ESP32-S3 Ethernet board files both configure a W5500.
How Does YamBMS Merge Multiple ESS BMS Units for One Inverter Over W5500 Ethernet?
Benjamin
Views 145
Comments 0
OpenKNX REG1 is an open hardware DIN-rail platform whose REG1-App-Eth board adds a WIZnet W5500 to an RP2040, bridging a KNX twisted-pair line and KNX-IP.
OpenKNX REG1: A Bus-Powered DIN-Rail KNX-IP Router on RP2040 and W5500
Benjamin
Views 190
Comments 0
BREMA firmware makes busware's TUL KNX stick answer MCP over HTTP, so an agent can commission KNX devices. A PoE W5500 extension is the wired path.
How Does BREMA Make a KNX Stick Its Own MCP Server, and Where Does PoE W5500 Fit?
Benjamin
Views 252
Comments 0
DEYE GE-F128 ESS manuals link optional RJ45 Ethernet, TCP/IP and Modbus support, and F055 W5500 SPI communication failure.
How Does DEYE GE-F128 ESS Expose W5500 for TCP/IP Diagnostics?
Benjamin
Views 551
Comments 0
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?