This system is used to identify moisture in the field and apply proper requirement of water when required
3
Arduino - Arduino 101
x 1
Arduino microcontroller is curd control the moisture sensors and motor
Arduino - Arduino IoT Cloud
x 1
The sensed result is upload in the iot cloud and we can find the result in cloud
This project is used for the smart supply of water to the field
A WIZnet W5500, a 25.000 MHz crystal and a HanRun HR911105A jack. Augmatic Technologies of Vadodara sells it at INR 425, below its own ENC28J60 board.
What Is Inside the WittelB WIN-MD-W5500, an Own-Brand W5500 Module from India?
Benjamin
Views 118
Comments 0
In this open KiCad gateway an ADIN1110 holds the 10BASE-T1L pair and a W5500 carries it onto standard Ethernet, both on one ESP32-S3 over separate SPI buses.
How Does a 10BASE-T1L Field Port Reach Standard Ethernet Through a W5500?
Benjamin
Views 159
Comments 0
Somon's Halow-GW Wi-Fi HaLow gateway spends all eight W5500 hardware sockets on three TCP servers, two TCP clients, two UDP channels and one HTTP listener.
Where Do the Eight W5500 Hardware Sockets Go in Somon's Halow-GW?
Benjamin
Views 176
Comments 0
PP-Ethernet-UART-HAT is a 45 x 30 mm PLATYPUS module that converts 3.3 V UART to Ethernet on a WIZnet W55RP20 and ships with W55RP20-S2E firmware preloaded.
Which PLATYPUS W55RP20 Module Converts 3.3 V UART to Ethernet Without Custom Firmware?
Benjamin
Views 103
Comments 0
hexinttp's ESP-IDF firmware maps Modbus RTU and TCP registers to named points, publishes them over MQTT, and serves 11 MCP tools, with W5500 as default route.
How Does an ESP32-S3 Modbus Gateway Serve Field Points as MCP Tools over W5500 Ethernet?
Benjamin
Views 289
Comments 0
Alexey Titov's Eva node fits a wall box by splitting in two: sensors and a W5500 on the front PCB, RJ45 and a PoE module on the back.
How Does the Eva Wall-Box PoE Sensor Split W5500 Ethernet Across Two Boards?
Benjamin
Views 220
Comments 0
YamBMS is an ESPHome project that merges parallel BMS units into one battery for the inverter. Its two ESP32-S3 Ethernet board files both configure a W5500.
How Does YamBMS Merge Multiple ESS BMS Units for One Inverter Over W5500 Ethernet?
Benjamin
Views 201
Comments 0
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
