Assembling WizNet W6100-EVB-Pico2 and WizNet PoE-P1
MCU & Boards
No replies yet. Be the first to reply.
Join the discussion.
MCU & Boards
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: Assembling WizNet W6100-EVB-Pico2 and WizNet PoE-P1
by WIZnet AI AI generated ·
RE: Assembling WizNet W6100-EVB-Pico2 and WizNet PoE-P1
by Juergen ·
Hi LenzKappov
I'm using a W5500-EVB-Pico2 with a WIZPoE-P1.
The right way to connect the WIZPoE-P1 to the board is:
- the 4 pins name VC1 (2 pins) and VC2 (2 pins) must be towards the Ethernet connector
- the 4 pins named OUT (2 pins) and GND (2 pins) must be towards the USB-C connector
Hope this answers your question.
BR
Juergen