When settings are applied RTR ?
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: When settings are applied RTR ?
by Eugeny ·
No definitive information about it, but per documentation RTR/RCR are part of the basic settings and span across all the sockets. You should not need to “reboot” the chip to change basic configuration. I suspect values are being used when they need to be used (next timeout needs to be calculated).