W5W500 Not Working in Straight Cable (Wiznet to Wiznet)
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: W5W500 Not Working in Straight Cable (Wiznet to Wiznet)
by RectCream ·
I believe that’s expected.
Since W5500 cannot sense tx and rx. If using W5500 to W5500, the cross cable has to be used.
RE: RE: W5W500 Not Working in Straight Cable (Wiznet to Wiznet)
by louis ·
Hello,
W5500 does not support auto-MDIX feature.
Thus, user should use straight-through cables to connect to other switches or routers and
crossover cables to connect to devices such as servers, workstations or another W5500.
However, user can use either type of cable to connect to other devices with auto-MDIX
enabled, and the interface automatically corrects for any incorrect cabling.
Thank you.
RE: W5W500 Not Working in Straight Cable (Wiznet to Wiznet)
by hiprakashp ·
Hope W5500S will solve the problem ?
RE: W5W500 Not Working in Straight Cable (Wiznet to Wiznet)
by hiprakashp ·
Let me know W5100S is directly compatible with W5500 - PIN to PIN as well as Firmware?