WizFi360 Arduino IDE JSON package error
General
No replies yet. Be the first to reply.
Join the discussion.
General
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: WizFi360 Arduino IDE JSON package error
by austin ·
Hello,
Unfortunately, the Arduino library you mentioned does not support it.
If you want to use the Arduino library, please refer to the link below.
RE: RE: WizFi360 Arduino IDE JSON package error
by dekip ·
But, did it supported earlier? Is this your page? I am not talking about the library, I am talking about the JSON package. Not the same.
Will there be a support for an Arduino IDE? To program this board as a stand-alone device?
The library you mention I haven’t tried, yet.
RE: WizFi360 Arduino IDE JSON package error
by austin ·
Sorry,
Where the JSON packages were supported, support has been stopped.
So, the device alone can not be programmed using Arduino IDE.
RE: RE: WizFi360 Arduino IDE JSON package error
by dekip ·
Pitty…
The support through Arduino IDE would give this platform a huge boost. This way, it is a way unusable.
Can you tell me if there was support, if it worked, why you stopped it?
Is there a plan to start supporting IDE again?
RE: WizFi360 Arduino IDE JSON package error
by austin ·
Hello,
Where the JSON packages were supported, support has been stopped, so we can no longer support.
Sorry, we don’t have any plans to support WizFi360 to be programmable as an Arduino IDE.