Running chips without MagJack attached
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: Running chips without MagJack attached
by Edward ·
Hi.
TCP/IP device is Not damage without PHY and Magjack.
But, caution !
What kind using the chip?
refer to bellow W5500 reference circuit and check to Wizwiki.net (forum site)
wizwiki.net/wiki/doku.php?id=pro … fschematic
Thank you
RE: Running chips without MagJack attached
by Eugeny ·
Thank you.
W5100
Which caution?
RE: Running chips without MagJack attached
by Edward ·
Caution is schematic design.
You design correct circuit, otherwise dangerous.
So, refer to below site
wiznet.co.kr/product-item/w5100/
check the HW Design Guide Tap.
It is W5100 Reference circuit.
Thank you
RE: Running chips without MagJack attached
by Eugeny ·
Edward, you seem to answer different question.
Assume that schematic is fully correct, but I do not solder MagJack connector. Is there any danger?
RE: Running chips without MagJack attached
by Edward ·
It is not danger.
Just RJ-45 and Transformer use reason is communication to other peer.
you just checking phy signal? It is not danger
thank you
RE: Running chips without MagJack attached
by Eugeny ·
Thank you.