Sharc dsp with w5500
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: Sharc dsp with w5500
by bangbh ·
??? I can’t understand what you posted.
RE: Sharc dsp with w5500
by vport ·
I want to add ethernet to analog devices DSP .This DSP has sport instead of SPI PORT .sport can be emulated as SPI I need drivers for DSP to add ethernet to DSP .Is any diriver availble to do above work thanks
RE: Sharc dsp with w5500
by Coccoliso ·
Hello,
first of all you’re talking about a microprocessor?
If you have only a serial port can not directly attack the W5500 since it only has a SPI port to communicate.
With four lines IO can simulate a SPI but you have to create the protocol from scratch and is not a joke.
If the processor has at least a dozen lines you can communicate in parallel with a different type ETH device like a W5100 and may be relatively simple.
But if you’re talking about a serial device (not a microcontroller) that has a serial port then first you have to connect the device to a microcontroller that can command the W5500 also through its SPI port … then first you have to decide which microcontroller use.