Wiz107sr - data default
Serial-to-Ethernet & ConfigTool
No replies yet. Be the first to reply.
Join the discussion.
Serial-to-Ethernet & ConfigTool
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: Wiz107sr - data default
by liv ·
I know where is the last firmware. Configuration tool (v1.4.4.2) not find the device and showing all the tabs and more buttons forbidden (gray). So I can not use the program to reset the settings to default. So I wanted to ask the default values explicitly in writing data. Prompt how to set default values differently.
RE: Wiz107sr - data default
by irina WIZnet ·
Hi liv.
Do you have WIZ107SR-EVB module?
If you have, possible to reset the settings to default using [Factory Reset] button.
(refer to WIZ107SR User’s manual)
But, ‘factory reset’ function is recover to default configuration values only - Isn’t change the firmware binary.
I think, ‘Search’ function must succeed on a priority basis.
Search function based on UDP protocol.
Would you please check or turnoff the ‘Windows-firewall’ (or firewall of anti-virus programs) ?
Additionally, please refer to ‘WIZ107/108SR S2E Programming Guide’ document for data format.
wiznet.co.kr/UpLoad_Files/Re … _V100E.pdf