Wiznet makers

This article presents a maker-oriented architecture for adding wired Ethernet to a Xiaozhi AI local server with the W5500.

This source describes a maker-oriented Ethernet access design for a Xiaozhi smart speaker using the W5500 as a hardware TCP/IP controller over SPI.

Custom PCBs integrate W5500/ENC28J60 to enable industrial Ethernet communication between the PLC and slave controllers for robotic pipetting.

This source is an architecture-level introduction to WIZnet’s ioLibrary_Driver rather than a board-specific implementation, but it is still useful for education

inettools-z80

This source is an architecture-level introduction to WIZnet’s ioLibrary_Driver rather than a board-specific implementation,

This source is an overview of WIZnet’s ioLibrary_Driver rather than a board-specific project, but it is still useful for education because it shows how WIZnet o

Auditory Nuisance Machine: A Network-Controlled Sound IoT Device on AVR and W5500

This project uses an STM32F103C8T6 with a W5500 Ethernet controller to build a wired embedded node that supports UDP, TCP server, TCP client, MQTT, HTTP, DHCP,

This source is an architecture-oriented introduction to pairing ESP32 or ESP32-S3 with the W5500 for wired Ethernet applications.

This article focuses on using an ESP32 with a W5500 Ethernet module under ESP-IDF, with emphasis on static IP setup,

.

This article presents an ESP32 + W5500 design aimed at MicroPython-based Ethernet access, with emphasis on board-level wiring,

This project shows how to integrate a W5500 with ESP32-S3 under ESP-IDF, with emphasis on SPI stability,

By analyzing WIZ550io schematics, this project reconstructs a hardware TCP/IP offload architecture over SPI, enabling deterministic, low-overhead ethernet.

STM32F401 + W5500 edge controller enables real-time MQTT over hardware TCP/IP offload for deterministic, fail-safe wind turbine control.

Community-contributed PR adds WIZnet W6100 Ethernet driver to ESP-IDF, enabling IPv4/IPv6 dual-stack communication over SPI on ESP32.

ESP32 AirPlay 2 Receiver

.

Flask-app-for-displaying-data-using-ESP32-and-W5500

MonRK

Spool prints using a virtual COM port with a WIZnet Serial-to-Ethernet adapter

This is a real-time EtherCAT master application to control EtherCAT slave devices(e.g. epos4, elmo)

da_rpfir