[From QnA] Wiz100SR Hardware Configuration Mode

Question

Hi, I wish to use the hardware configuration mode on the Wiz100SR, but am wondering what settings I need. There is no information about what RS-232 settings/ baud rate to use in the manual. I have previously configured the module to use 38K,8,n,1,CTS/RTS flow. Do I use that baud rate/setting or does the module only communicate at a pre-determined rate/setting? Thanks,

ywkwon · Answer

Dear customer, Thanks for your interest in Wiz100sr. There is no stated value. You can use as your setting value. I let you know about default value when product produce. Please refer to as below. Speed : 57600 Databit : 8 Parity : none Stopbit : 1 Flow : none Thanks, WIZnet