Wizfi360 TCP can’t retrive fully the response
Ethernet Chips
- STM32
No replies yet. Be the first to reply.
Join the discussion.
Ethernet Chips
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: Wizfi360 TCP can’t retrive fully the response
by WIZnet AI AI generated ·
RE: RE: Wizfi360 TCP can’t retrive fully the response
by fcampanini ·
Commands such as AT+RECV_TIMEOUT and AT+GETSOCKOPT do not exists in the documentation. Tested via tera term they both provide ERROR as response.
Fine to use AI to replay but maybe you should setup your own RAG to give correct answers on your technology.
Other suggestions?
RE: RE: Wizfi360 TCP can’t retrive fully the response
by Aimee0 WIZnet ·
When data truncation occurs, use a tool like Wireshark to check whether the Ethernet packets are received completely without being truncated.
Additionally, try connecting a serial module to the WizFi360 instead of the STM board and use a terminal program (e.g., Hercules, PuTTY) to verify whether the data is received correctly.