W5500-EVB-Pico2 doesn't reboot after flashing MicroPython
MCU & Boards
No replies yet. Be the first to reply.
Join the discussion.
MCU & Boards
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: W5500-EVB-Pico2 doesn't reboot after flashing MicroPython
by WIZnet AI AI generated ·
RE: RE: W5500-EVB-Pico2 doesn't reboot after flashing MicroPython
by Juergen ·
I'''ve performed all the steps described. The issue still exists.
Another brandnew board shows the same issue. The board revison Rev 1.0
Flashing flash_nuke.uf2 lets the W5500-EVB-Pico2 reboot.
RE: W5500-EVB-Pico2 doesn't reboot after flashing MicroPython
by Juergen ·
Solved:
Currently there is no MicryPython version available for the W5500-EVB-Pico2.
W5500_EVB_PICO-20241025-v1.24.0.uf2 works only with the W5500-EVB-Pico board.
See https://maker.wiznet.io/forum/15339 for details
RE: RE: W5500-EVB-Pico2 doesn't reboot after flashing MicroPython
by cecilyen ·
There’s a pull request on MicroPython’s GitHub to add support for the W5500-EVB-Pico2 and W5100S-EVB-Pico2. Check it out here: https://github.com/micropython/micropython/pull/16280
RE: W5500-EVB-Pico2 doesn't reboot after flashing MicroPython
by Gruber ·
I've made a firmware, see thread: https://maker.wiznet.io/forum/15529
RE: W5500-EVB-Pico2 doesn't reboot after flashing MicroPython
by TheoIm WIZnet ·
The .uf2 file W5500_EVB_PICO-20241025-v1.24.0.uf2 was built for the PICO (RP2040) and is likely not compatible with the PICO2 (RP2350).
Expected Issue: Differences between RP2040 and RP2350 The PICO2 uses the RP2350, but the current MicroPython firmware was likely built targeting RP2040.
Since the RP2350 has some hardware differences from the RP2040, a .uf2 file built for the RP2040 may not run properly on the RP2350.
Therefore, I recommend testing the firmware on an RP2040 board first to confirm that it boots properly. If it does, then this firmware is not compatible with the PICO2.
Regards.