W7500 external programmer
MCU & Boards
No replies yet. Be the first to reply.
Join the discussion.
MCU & Boards
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: W7500 external programmer
by irina WIZnet ·
If you want to upload the firmware, you should use the isp tool.
This link is about isp tool.
RE: RE: W7500 external programmer
by polemon ·
Hi, I was just looking for quite a while where to attach the USB<->Serial adapter to the WIZnet chip in order to flash the firmware.
I was expecting that to be explained in the datasheet for the W7500(P) or the W7500P-S2E (the pre-programmed MCU).
However, all the datasheets only mention that depending on the BOOT pin, the MCU either boots into the SPI bootloader or not. Nowhere in the datasheet it is explained how to connect a serial adapter to the MCU in order to flash firmware onto it.
Isn’t that a bit of an oversight? I’d expect that information to be present in the datasheet, etc.
RE: W7500 external programmer
by Reheld ·
You can find the information in the ISP tool manual. UART2 should be used.
Different vendors of programming equipment already implemented the W7500 programming algorithm e.g. SEGGER and PEmicro.
If you need a Solution for high volume board production, you should contact specialised equipment manufacturers.