WIZ145SR - Uart 1 keeps reconnecting in Client mode
Serial-to-Ethernet & ConfigTool
No replies yet. Be the first to reply.
Join the discussion.
Serial-to-Ethernet & ConfigTool
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: WIZ145SR - Uart 1 keeps reconnecting in Client mode
by Matthew ·
Hello.
UART1 means Channel #1 right?
Can you check HW Trigger SW pin ‘ON or OFF?’
If you set HW Trigger SW pin to ON, then UART1(Channel #1) will operate Serial Command mode.
RE: RE: WIZ145SR - Uart 1 keeps reconnecting in Client mode
by PJB Technical ·
Yes I have done that. When on I can communicate but when off it still behaves this way
Even if I disable in the setup
RE: WIZ145SR - Uart 1 keeps reconnecting in Client mode
by Matthew ·
hello.
I also asked the engineer in charge, and as a result of actually conducting the test, I was able to confirm that UARTs 1 to 4 were operating normally.
In order to solve the problem, it would be good to show the configuration tool setting values and wire shark packets from the server for all UARTs.
Also, it would be good to make a UDP server on the PC and try the test.
My email address is matthew@wiznet.io.
thank you