WIZFI360-CON ANT pin
Wireless
No replies yet. Be the first to reply.
Join the discussion.
Wireless
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: WIZFI360-CON ANT pin
by Brammert42 ·
Hi,
I also measure the UFL connector and I noticed that the centre pin is shorted to the other ring of the UFL.
I think its because its soldered to the gnd by the pin i marked in the picture below.
RE: RE: WIZFI360-CON ANT pin
by bruno WIZnet ·
Thank you for purchasing the WizFi360-con module.
Existing connectors should not be used if the connector is to be used externally.
You need to remove the existing connector and connect it with a line. You can use it externally by performing impedance matching. (Not recommended.)
RE: WIZFI360-CON ANT pin
by Brammert42 ·
Hi Bruno,
Could you also comment on the UFL being shorted to gnd on the module? (i meant that the UFL on the module has the middle pin shorted to gnd)
Is there a version of this module I could buy that doesn’t need rework?
-Bram