BREAK - Command (WIZ105SR ; WIZ100SR)
Serial-to-Ethernet & ConfigTool
No replies yet. Be the first to reply.
Join the discussion.
Serial-to-Ethernet & ConfigTool
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: BREAK - Command (WIZ105SR ; WIZ100SR)
by jameskim ·
Hello Matthias,
Sending BREAK command is out of scope of WIZ105SR.
All our serial to Ethernet modules including WIZ105SR just forward all data between UART and Ethernet transparently.
If you input HEX data set for BREAK command on Serial side or Ethernet side, then those will be transferred to the peer side without loss.
Tera Term has a function for sending BREAK command when it runs as serial terminal but it seems not to support it in TCP/IP mode.
I don’t know HEX code of Tera Term’s BREAK command.
But if you know it something like 0x1E, you can send it from any TCP/IP socket application supporting HEX data.
Hercules is capable of sending HEX data, I know.
I hope this is helpful to you.
James.