Unable to enter Data Mode with UDP socket
Wireless
No replies yet. Be the first to reply.
Join the discussion.
Wireless
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: Unable to enter Data Mode with UDP socket
by wizdaniel ·
hi
which firmware version did you use?
UDP data mode was operated normally when I tried the F/W 1.0.3.3 official version.
but upper version firmware didn’t operate a data mode in UDP.
Thank you for found the bug.
This bug will be fixed.
RE: Unable to enter Data Mode with UDP socket
by robiz ·
v1.0.3.3 is bugged
If I set it with webserver works fine, after reset UDP connection is automatically connected.
If I do it manually, does not work:
AT+SCON=SO,USN,8888,1
AT+MPROF=S
…reset…
join WiFi but still it command mode, without socket connected automatically:
AT+SCON=?
SO,USN,0.0.0.0,0,8888,1
[OK]
Socket is present but not connected; AT+SDATA does not work.
The only way is to redo all:
…reset…
AT+SMGMT=ALL <<–necessary
AT+SCON=SO,USN,8888,1
…now socket is connected and in data mode.
In brief, an UDP profile stored as SO,USN do not restarts automatically after reset.
RE: Unable to enter Data Mode with UDP socket
by robiz ·
The same problem if WiFi connection is lost and restored: the socket is not reconnected automatically.
Again, if I configure it with module’s webserver, works fine restoring connection automatically.