WIZ5500io and Arduino DUE

Question

Hello, I connect WIZ550io on my Arduino Due as show attached picture. Arduino Due programming with this code: [code] #include #include // Enter a MAC address and IP address for your controller below. // The IP address will be dependent on your local network: #if defined(WIZ550io_WITH_MACADDRESS) // Use assigned MAC address of WIZ550io ; #else byte mac = {0xxx, 0xxx, 0xxx, 0xxx, 0xxx, 0xxx}; #endif IPAddress ip(192,168,1,150); // Initialize the Ethernet server library // with the IP address and port you want to use // (port 80 is default for HTTP): EthernetServer server(80); void setup() { // Open serial communications and wait for port to open: Serial.begin(9600); while (!Serial) { ; // wait for serial port to connect. Needed for Leonardo only } // start the Ethernet connection and the server: #if defined(WIZ550io_WITH_MACADDRESS) Ethernet.begin(ip); #else Ethernet.begin(mac, ip); #endif server.begin(); Serial.print("server is at "); Serial.println(Ethernet.localIP()); } void loop() { //dodaj čakanje vsaj 500ms zaradi drugega posta: WIZ550io and Arduino Pro Micro // listen for incoming clients EthernetClient client = server.available(); if (client) { Serial.println(“new client”); // an http request ends with a blank line boolean currentLineIsBlank = true; while (client.connected()) { if (client.available()) { char c = client.read(); Serial.write(c); // if you’ve gotten to the end of the line (received a newline // character) and the line is blank, the http request has ended, // so you can send a reply if (c == ‘ ’ && currentLineIsBlank) { // send a standard http response header client.println(“HTTP/1.1 200 OK”); client.println(“Content-Type: text/html”); client.println(“Connection: close”); // the connection will be closed after completion of the response client.println(“Refresh: 5”); // refresh the page automatically every 5 sec client.println(); client.println(“”); client.println(“”); // output the value of each analog input pin for (int analogChannel = 0; analogChannel < 6; analogChannel++) { int sensorReading = analogRead(analogChannel); client.print(“analog input “); client.print(analogChannel); client.print(” is “); client.print(sensorReading); client.println(” ”); } client.println(“”); break; } if (c == ‘ ’) { // you’re starting a new line currentLineIsBlank = true; } else if (c != ‘ ’) { // you’ve gotten a character on the current line currentLineIsBlank = false; } } } // give the web browser time to receive the data delay(1); // close the connection: client.stop(); Serial.println(“client disonnected”); } }[/code] When Code running show me on Serial port this message: server is at 0.251.251.251 IP is static from tomato firmware on lynksys wrt54gl router. If I would like to Ping wiznet get this [code] Microsoft Windows [Version 6.1.7601] Copyright (c) 2009 Microsoft Corporation. All rights reserved. C:\Users\Grega>ping 192.168.1.150 Pinging 192.168.1.150 with 32 bytes of data: Reply from 192.168.1.14: Destination…

drVrh · Answer

Ideas? Why is writes on the WizWiki site of the module being connectable with Arduino? What I’m doing wrong?

bangbh · Answer

Hi, drVrh. You didn’t connect SCSn pin. SCSn is chip select pin for W5500 IC. And why don’t you try with arduino ethernet shield? [url]Arduino - Home