WizFi250 throughput
Wireless
No replies yet. Be the first to reply.
Join the discussion.
Wireless
No replies yet. Be the first to reply.
Join the discussion.
Share projects and connect with makers.
Joined before the site update? first.
New to WIZnet Makers?
We sent a verification link to your address. Open it to activate your account, then log in.
Accounts from this email provider are reviewed by an administrator after verification. Approval usually takes one business day.
Already have an account?
Enter your email address. If it belongs to an account, we'll send a link to set a new password. Members who joined before the site update use this to set their password.
If an account uses that address, we sent a link to set a new password. The link works once and expires in 30 minutes.
Know your password?
Need an account?
RE: WizFi250 throughput
by ssekim ·
Hello Georgiy
<65 MBit/s> is just WiFi physical link rate.
is another issue.
Please refer to the below link.
[url]http://wizwiki.net/wiki/doku.php?id=products:wizfi250:wizfi250pg:start#wizfi250_uart_throughput_test_report[/url]
RE: WizFi250 throughput
by Georgiy ·
So, max wifi transfer speed is 1.74Mbit/s?
That would not be enough for camera.
RE: WizFi250 throughput
by ssekim ·
Hello Georgiy
—(A. UART)——(WiFi)—
Maybe is over 10Mbit/s(physical rate is 65MBit/s).
But, in above diagram, camera will send the camera-data to WizFi250 via .
So I think that depends more on thatn on .
That is why is under 2 Mbit/s.
RE: WizFi250 throughput
by Georgiy ·
Hello ssekim!
The diagram is —(WiFi)——(WiFi)—.
So no uart here, and throughput is quite enough.
Thank you!
RE: WizFi250 throughput
by ssekim ·
Hello Georgiy
In fact, I didn’t test throughput without UART interface.
But, I believe that it would be more than what you expected.