Digital Thermostat for Burner and Boiler with Remote Monitor
Digital Thermostat for Burner and Boiler with Remote Monitor
0
Components
Hardware components
Arduino - Arduino Nano R3
x 2
WIZnet WIZ750SR
x 2
PT1000 sensor
x 2
Maxim Integrated max31865 RTD
x 2
Project description
Story Here the digital thermostat stops the pump to run when it detects that the temperature of the hot water tank is higher than the burner temperature If users use hot water and temperatures resist, the digital thermostat allows the pump to operate again.(After three starts the burner stops at 60 degrees but the temperature will reach about 70degrees.) The hot water pump starts at 40 degrees.The pump starts to circulate the water between the burner and the hot water tank by bringing the hot water temperature from ambient temperature to 50. The WIZ750SR is a Serial to Ethernet module.This…
Keep reading with a free account
Guests can read 15 projects per visit. Log in or create a free account to read the full description, open the documents and join the comments.
