Wiznet makers

Run a lightweight HTTP web server on STM32 NUCLEO476RG using W5500 via SPI with hardware TCP/IP offload and multi-socket support.

빙진 모니터링 시스템의 개발 및 시험 운영 결과

This project uses an STM32H723VGT6 to read three FDCAN buses, timestamp and serialize the frames, and stream them to a remote server over WebSocket

This project implements a slow-control and interlock pipeline on a Cologne Chip GateMate M1A1 FPGA, using WIZnet W5500 devices as the Ethernet

Apache Mynewt is a modular RTOS platform for microcontrollers, built around a preemptive kernel, package-based builds, and remote device management tools.

W6300 Low level Link speed tes

ProsecCoAP + Low-Level Link Speed Tests 프로젝트 분석

RoboPro2026 Ethernet_Yoshiharu

CircuitBase

T.E.E.M.O is an ESP32-S3 CanSat platform combining 433 MHz telemetry, thermal logging, and a W5500 Ethernet camera link for mission-grade student avionics.

A Linux kernel training repository that connects platform binding, SPI Ethernet integration, and a minimal filesystem through staged driver exercises.

RetroBox

ESP32 handheld SD browser with OLED UI and a partial W5500 Ethernet offload path for TCP file transfer; novel embedded utility, but not a TOE-based design.

SinricPro_Generic

Minimal C++ library for ESP32/RP2040 to communicate with Mitsubishi PLCs via SLMP 4E protocol. Supports W5500 Ethernet for stable factory connections. Arduino &

ESP32-C6 bridges Art-Net DMX to Zigbee smart lights via W5500 Ethernet. Offloads UDP/6454 reception to free RF for Zigbee. Web UI for DMX patch & group config.

Open-source KiCad PCB acting as a power distribution and SPI hub motherboard for W5100S/W5500-EVB-Pico, driving six LED lamp units in a university building-scal

DMX512 is one of the most widely used protocols in lighting control

This project describes a maker-oriented edge-device architecture that combines the W5500 with local encryption and integrity checks so an MCU-class system can k

This article describes a maker-oriented edge gateway design that uses the W5500 to run a local TCP server with an emphasis on low latency,

This project is a compact W5500 porting note focused on bringing up a basic network stack on an MCU by transplanting WIZnet’s official driver files, adding a ha

This project shows how to bring up the W5500 as a TCP server on an AG32VF407 board by transplanting a simple W5500 socket example, adding board-specific GPIO an

This source is a hardware-and-protocol primer for the W5500 rather than a complete application project.

This project uses an STM32F103C8T6 with a W5500 Ethernet controller to build a small wired networking platform that can run UDP, TCP server, TCP client, MQTT