---
title: "MT011 is an RC2014 compaitible ethernet controller based on the w5500"
url: "https://maker.wiznet.io/sophia/projects/MT011-is-an-RC2014-compaitible-ethernet-controller-based-on-the-w5500/"
markdown_url: "https://maker.wiznet.io/sophia/projects/MT011-is-an-RC2014-compaitible-ethernet-controller-based-on-the-w5500/md"
type: "UCC: User Created Content"
author: "sophia"
author_url: "https://maker.wiznet.io/sophia/"
original_author: "sophia"
original_url: "https://github.com/durgadas311/cpnet-z80/blob/master/md/MT011.md"
published: "2022-02-28"
language: "en"
likes: 0
views: 299
comments: 0
source: "WIZnet Makers (https://maker.wiznet.io/)"
---

# MT011 is an RC2014 compaitible ethernet controller based on the w5500

> MT011 is an RC2014 compaitible ethernet controller based on the w5500

Original author: sophia (source: https://github.com/durgadas311/cpnet-z80/blob/master/md/MT011.md)

## Article

### Description

The?[mt011](https://github.com/markt4311/MT011)?is an?[RC2014](http://www.rc2014.co.uk/)?compaitible ethernet controller based on the?[w5500](https://www.wiznet.io/product-item/w5500/)?wiznet chip with a?[Featherwing](https://learn.adafruit.com/adafruit-wiz5500-wiznet-ethernet-featherwing)?breakout board.

This board was developed by Mark T with input from Jay Cotton.

### <https://github.com/durgadas311/cpnet-z80/blob/master/md/MT011.md#building>Building

make NIC=w5500 HBA=mt011

### <https://github.com/durgadas311/cpnet-z80/blob/master/md/MT011.md#using>Using

To run this board with CP/NET there are a few things that are needed. A ROM/RAM board with?[RomWBW](https://github.com/wwarthen/RomWBW)?v3.0.1 or newer. The MT011 board.

The MT011 does not reset the W5500 during system RESET, so it retains settings during system RESET-reboot. The W5500 may be reset by software, when required.

##On your CP/M console: ###CP/M 2.2

```
b:pip a:=c:ccp.spr  (assumes your cpnet code is installed on the c drive)
c:ifconfig -s (https://github.com/jayacotton/inettools-z80)  (this command gets a DHCP address for the wiznet board)
c:wizcfg 0 0 <host ip address> 31100 45
c:cpnetldr  (this loads the cpnet bios code )
c:network k:=c:[0]  (k on my machine, YMMV)
```

###CP/M 3.0

```
c:ifconfig
c:wizcfg 0 0 <host ip address> 31100 45
c:network k:=c:[0]
```

##Caveat's

The above assumes you have a server running on a host machine somewhere. See cpnet-z80/doc/CpnetSocketServer.pdf for information on running the server.

---

Source: https://maker.wiznet.io/sophia/projects/MT011-is-an-RC2014-compaitible-ethernet-controller-based-on-the-w5500/