---
title: "WSET and WSEC not being saved"
url: "https://maker.wiznet.io/forum/13444"
markdown_url: "https://maker.wiznet.io/forum/13444/md"
type: "Forum topic"
category: "Wireless"
author: "Luis Villegas"
created: "2019-08-19T14:13:38+09:00"
last_activity: "2019-08-22T22:40:27+09:00"
language: "en"
views: 555
replies: 3
source: "WIZnet Makers forum (https://maker.wiznet.io/forum/)"
---

# WSET and WSEC not being saved

## Question

Asked by Luis Villegas on 2019-08-19 in Wireless.

Hi there,
I keep testing the module, and detected that the network instructions state that they are being saved, without calling the MPROF=S at instruction.
Y tested multiple time and noted that if i set up the network configuration, and reset the module without calling the MPROF=S instruction, that configuration get lost.

## Replies

### Reply 1 by wizdaniel, 2019-08-19

Hi

Most of configurations can be stored in Flash drive with +MPROF=S.
but, the commands regarding Network attachment, such as +WSET, +WNET, +WSEC, can be stored in Flash drive directly when you type that commands without +MPROF=S.

you should type +MPROF=S commands to store configuration. if you want to store some configurations like module config, auto connection and so on.

which commands did you lost?

### Reply 2 by Luis Villegas, 2019-08-20 (in reply to reply 1)

Hey there,
thanks for the follow, those commands that i was talking about, were precisaly wset, wnet and wsec, they are not being stored, when i called them. I checked this by set them up, and then resetting the module, it will always start with the default configurations.
So, what i think is that every configuration must be stored by using MPROF=S, the datasheet is wrong about the commands that states “autosaving”

### Reply 3 by wizdaniel, 2019-08-22

thanks, I will check about that

---

Source: https://maker.wiznet.io/forum/13444