---
title: "Frequent Rebooting of WIZ110SR"
url: "https://maker.wiznet.io/forum/11362"
markdown_url: "https://maker.wiznet.io/forum/11362/md"
type: "Forum topic"
category: "Serial-to-Ethernet & ConfigTool"
author: "sivaprakash"
created: "2015-10-08T04:26:00+09:00"
last_activity: "2017-05-04T08:37:03+09:00"
language: "en"
views: 523
replies: 1
source: "WIZnet Makers forum (https://maker.wiznet.io/forum/)"
---

# Frequent Rebooting of WIZ110SR

## Question

Asked by sivaprakash on 2015-10-08 in Serial-to-Ethernet & ConfigTool.

Dear All,

We need to receive the data from various IP address to a device through WIZ110SR.

Wiz110SR is connected to one Server IP for TCP/IP protocol, If we need to get data from another IP address, then again we need to configure the WIZ110SR and Reboot the same.

So due to frequent rebooting the WIZ110SR cause any issue ?

Is there any other way to connect to different IP address without reboot the WIZ110SR.

Thanks in advance.

## Replies

### Reply 1 by jim, 2015-10-08

Dear sivaprakash

If you want to use multi port, I recommend WIZ140SR or WIZ145SR.
4 port(socket) are supported in WIZ140/145SR.
Refer to [url][http://www.wiznet.co.kr/product-item/wiz140sr/\[/url\]](http://www.wiznet.co.kr/product-item/wiz140sr/%5B/url%5D) and [url][http://www.wiznet.co.kr/product-item/wiz145sr/\[/url\]](http://www.wiznet.co.kr/product-item/wiz145sr/%5B/url%5D)

If you need more connection, you have to implement the firmware of your prototype board to used WIZnet’s chip.
Max. 8 sockets are supported in WIZnet’s chip.
Refer to datasheet of W5500. [url][http://wizwiki.net/wiki/doku.php?id=products:w5500:start\[/url\]](http://wizwiki.net/wiki/doku.php?id=products:w5500:start%5B/url%5D)

Thanks.

---

Source: https://maker.wiznet.io/forum/11362