---
title: "Using GPIO Pins"
url: "https://maker.wiznet.io/forum/10241"
markdown_url: "https://maker.wiznet.io/forum/10241/md"
type: "Forum topic"
category: "Serial-to-Ethernet & ConfigTool"
author: "Dupinik"
created: "2014-05-18T09:39:23+09:00"
last_activity: "2017-05-04T08:33:02+09:00"
language: "en"
views: 758
replies: 1
source: "WIZnet Makers forum (https://maker.wiznet.io/forum/)"
---

# Using GPIO Pins

## Question

Asked by Dupinik on 2014-05-18 in Serial-to-Ethernet & ConfigTool.

Hello all,

I managed to upgrade FW version to 1.0 with another computer. Is there any guide how to use GPIO pins?
I need some command to control them. I would like to use them to reset other device remotely.

Thank you.

## Replies

### Reply 1 by ywkwon, 2014-05-29

Hi,

GPIO is controled via web page only.
Open the web page as below.
“<http://module>’s IP/gpio.html”

---

Source: https://maker.wiznet.io/forum/10241