---
title: "How to auto reconnect with AP in multi bridge mode"
url: "https://maker.wiznet.io/forum/10045"
markdown_url: "https://maker.wiznet.io/forum/10045/md"
type: "Forum topic"
category: "Wireless"
author: "xiaoxiu"
created: "2014-03-14T09:40:24+09:00"
last_activity: "2017-05-04T08:31:58+09:00"
language: "en"
views: 463
replies: 1
source: "WIZnet Makers forum (https://maker.wiznet.io/forum/)"
---

# How to auto reconnect with AP in multi bridge mode

## Question

Asked by xiaoxiu on 2014-03-14 in Wireless.

Hi:
I am now working in multi bridge mode. I try to restart AP, but wiz630 didn’t reconnect with the AP. After that i manually restart wiz630, the connection regenerated. Is there any solution that I don’t need to restart 630, and it auto reconnect with the AP after connection lost.

## Replies

### Reply 1 by kaizen, 2014-03-17

Hi

I did test about this issue. But WizFi630 could operate well.
Please check the difference between my environment and yours.

My Test Environment is as below.

WizFi630’s Firmware version is <1.1.29(20131112)> and operate Multi-Bridge Mode.
After connecting to AP, I try to turn off AP(model : IpTimeN604M) and then I check wi-fi status using command. WizFi630 did output . it means disconnected with AP.

After 10 minute, I try to turn on AP and then I did check wi-fi status using command. WizFi630 did output <S1_WiznetKaizen_0026667B9DB0_7_150_46>. It means that WizFi630 reconnected to AP well.

I will send 1.1.29 firmware via your e-mail. maybe you don’t have it.

---

Source: https://maker.wiznet.io/forum/10045